Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5.3.2 Checking configurations
Use the following commands to check configuration results.
No.
1
2
5.3.3 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Raisecom(config)#clear arp
5.3.4 Example for configuring ARP
Networking requirements
As shown in Figure 5-2, the ISCOM2600G-HI series switch is connected to the host, and is
also connected to the upstream Router through GE 1/1/1. For the Router, the IP address and
submask are 192.168.1.10/24, and the MAC address is 0050-8d4b-fd1e.
To improve communication security between the Switch and Router, you need to configure
related static ARP entry on the ISCOM2600G-HI series switch.
Command
Raisecom#show arp [
interface-type
interface
interface-number
| static ]
Raisecom#show arp local-proxy
vlan-id
[ interface vlan
Command
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
ip-address
|
Show information about entries in the
ARP address table.
Show information about local proxy
]
ARP.
Clear all entries in the ARP address table.
Description
Description
5 IP services
215
Advertisement
Table of Contents
