Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
8
9
10
11
12
1.2.5 Managing users
When you start the ISCOM2600G-HI series switch for the first time, connect the PC through
Console interface to the ISCOM2600G-HI series switch, enter the initial user name and
password in HyperTerminal to log in and configure the ISCOM2600G-HI series switch.
By default, both the user name and password are raisecom.
If there is no privilege restriction, any remote user can log in to the ISCOM2600G-HI series
switch through Telnet or access network by establishing a PPP (Point to Point Protocol)
connection when service interfaces are configured with IP address. This is unsafe to the
ISCOM2600G-HI series switch and network. Creating user for the ISCOM2600G-HI series
switch and configuring password and privilege help manage login users and ensures network
and device security.
Default configurations of user management are as below.
Local user information
New user privilege
Command
Raisecom(config)#ssh2
port-
server port
number
Raisecom(config)#ssh2
server max-session
session-number
Raisecom(config)#ssh2
ip
access-list {
access-list number
ipv6 access-list
number
}
Raisecom(config)#ssh2
server rekey-interval
value
Raisecom(config)#
ssh2 server close
session-
session
number
Function
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
(Optional) configure SSHv2 snooping port
number.
By default, it is 22.
When configuring SSHv2 snooping port
number, the entered parameter cannot take
effect until SSH is restarted.
(Optional) configure the maximum number of
SSHv2 sessions.
(Optional) configure the ACL number.
|
(Optional) configure the SSH renegotiation time.
(Optional) close the specified SSHv2 session.
User name: raisecom
Password: raisecom
Privilege: 15
15
1 Basic configurations
Description
Default value
16
Advertisement
Table of Contents
