Checking Configurations; Maintenance; Example For Configuring L2Cp - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Applying a profile to an interface takes effect unless global L2CP is enabled. You can
configure it but it will not take effect if global L2CP is disabled.

2.12.7 Checking configurations

Use the following commands check configuration results.
1
2
3

2.12.8 Maintenance

Maintain the ISCOM2600G-HI series switch as below.
Raisecom(config)#clear l2cp-process tunnel
statistic [

2.12.9 Example for configuring L2CP

Networking requirements
As shown in Figure 2-25, configure L2CP on Switch A and Switch B as below.



No.
Raisecom#show l2cp-process profile
[ profile-number
Raisecom#show l2cp-process
[ interface-type interface-number
Raisecom#show l2cp-process
[ tunnel statistics ] [
type interface-number
Command
interface-type interface-number
Specify the multicast destination MAC address of them to 0100.1234.1234.
Configure the STP packets of Customer A to traverse the MAN, and discard other
packets.
Configure the STP and VTP packets of Customer B to traverse the MAN, send elmi
packets to the CPU, and discard other packets.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
]
interface-
]
Description
Show information about the
created L2CP profile.
Show configurations of L2CP on
]
the interface.
Show statistics about L2CP
packets on the interface.
Description
Clear statistics about L2CP
]
packets on the interface.
2 Ethernet
133