Default Configurations Of Garp; Configuring Basic Functions Of Garp - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

2.14.3 Default configurations of GARP

Default configurations of GARP are as below.
GARP Join timer
GARP Leave timer
GARP LeaveAll timer
Global GVRP status
Interface GVRP status
GVRP registration mode
Global GMRP status
Interface GMRP status
GMRP registration mode

2.14.4 Configuring basic functions of GARP

Configure basic functions of GARP for the ISCOM2600G-HI series switch as below.
1
2
3





Function
Step
Raisecom#config
Raisecom(config)#interface
interface-type interface-num
Raisecom(config-
gigaethernet1/1/port)#garp timer
{ join | leave | leaveall }
value
The value of the Join timer must be smaller than half of that of the Leave timer.
The value of the Leave timer must be greater than twice of that of the Join timer,
and smaller than that of the LeaveAll timer.
The value of the LeaveAll timer must be greater than that of the Leave timer.
In actual networking, we recommend configuring the Join timer, Leave timer, and
LeaveAll timer to 600, 3000, and 12000, in units of 10ms.
We recommend configuring the LeaveAll timer, Leave timer, and Join timer in
sequence, otherwise the restriction among their length may cause configuration
failure.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
20 (in units of 10ms)
600 (in units of 10ms)
1000 (in units of 10ms)
Enable
Disable
Normal
Disable
Disable
Normal
Command
time-
Default value
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure the GARP timer.
2 Ethernet
147