Configuring Static Multicast Members Of Vlan Copy; Configuring Customer Vlan Of Vlan Copy - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1
2
3

8.7.5 Configuring static multicast members of VLAN copy

Configure static multicast members of VLAN copy for the ISCOM2600G-HI series switch as
below.
Step
1
2
3



8.7.6 Configuring customer VLAN of VLAN copy

Configure the customer VLAN of VLAN copy for the ISCOM2600G-HI series switch as
below.
1
Step Command
Raisecom#config
Raisecom(config)#igmp
vlan-copy
Raisecom(config)#igmp
vlan-copy mcast-vlan
vlan-id
group
start-ip
{
| any }
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#igmp vlan-
copy mcast-vlan
address
user-vlan
IGMP Snooping and IGMP MVR cannot be enabled concurrently in the same
multicast VLAN, otherwise the configuration will fail.
IGMP Snooping and multicast VLAN copy cannot be enabled concurrently in the
same multicast VLAN, otherwise the configuration will fail.
Step Command
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enable global multicast VLAN copy.
Configure the group address set of the multicast
VLAN.
end-ip
[ ]
After multicast VLAN copy is enabled, you
need to configure the multicast VLAN and
bound group address set. If the received
IGMP Report packet does not belong to a
group address set of any VLAN, it is not
processed and the user cannot make
multicast traffic on demand.
Command
vlan-id
static
vlan-id
Description
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure static multicast
members of VLAN copy.
ip-
Description
Enter global configuration mode.
8 Multicast
354