Raisecom ISCOM2600G-HI (A) Series Configuration Manual page 279

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3
4
5
6





Configuring Type3 LSA filtering policy
Configure the Type3 LSA filtering policy for the ISCOM2600G-HI series switch as below.
Step Command
Raisecom(config)#access-list
acl-number
Raisecom(config-ipv4-
basic)#rule [
{ deny | permit } {
ip-address source-ip-mask
any }
Raisecom(config)#router ospf
process-id
router-id
]
Raisecom(config-router-
ospf)#distribute-list { ip-
access-list
prefix-list
Raisecom(config-router-
ospf)#distribute-list { ip-
access-list
prefix-list
[ static | connected | isis |
bgp]
Raisecom(config-router-
ospf)#distribute-list { ip-
access-list
prefix-list
process-id
ospf
Before configuring OSPF global distributing policy, ensure that the IP ACL used by
the OSPF global distributing policy has been created.
You cannot modify the IP ACL unless it is not used by any routing policy.
Different from IP ACL, the IP prefix-list can be modified even it is being used.
After global advertising policy is configured, routes cannot be redistributed to the
local LSDB unless it passes the global advertising policy. After protocol advertising
policy is configured, the route can be redistributed through the protocol advertising
policy.
After protocol advertising policy is configured, the redistributed protocol route can
be redistributed to the local LSDB through the protocol advertising policy. If global
advertising policy is also configured, the route must be redistributed through the
global advertising policy.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
rule-id
]
source-
|
[ router-id
acl-number
|
list-name
} out
acl-number |
list-name
} out
acl-number
|
list-name
} out
Description
Configure the IP ACL rule.
At present, the ISCOM2600G-HI series
switch just supports matching the
address prefix information of the route
by specifying the destination IP address
and subnet mask.
Configure basic IP ACL rules.
Enable an OSPF process and enter
OSPF configuration mode.
Configure the filtering policy that the
OSPF releases 5 types of LSAs to the
AS.
Configure the OSPF advertising policy.
5 IP services
248