Checking Configurations; Maintenance; Example For Configuring Mstp - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
1
2
3

2.7.21 Checking configurations

Use the following commands to check configuration results.
No.
1
2
3
4

2.7.22 Maintenance

Maintain the ISCOM2600G-HI series switch as below.
Raisecom(config-
gigaethernet1/1/port)#spanning-tree clear
statistics

2.7.23 Example for configuring MSTP

Networking requirements
As shown in Figure 2-18, three ISCOM2600G-HI series switch devices are connected to form
a ring network through MSTP, with the region name aaa. Switch B, connected with a PC,
belongs to VLAN 3. Switch C, connected with another PC, belongs to VLAN 4. Instant 3 is
associated with VLAN 3. Instant 4 is associated with VLAN 4. Configure the path cost of
instance 3 on Switch B so that packets of VLAN 3 and VLAN 4 are forwarded respectively in
two paths, which eliminates loops and implements load balancing.
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#spanning-tree
tc-rejection { enable | disable }
Command
Raisecom#show spanning-tree
Raisecom#show spanning-tree
instance-id
[ instance
type interface-list
Raisecom#show spanning-tree region-
operation
Raisecom(config-region)#show
spanning-tree region-configuration
Command
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
interface-
]
[ detail ]
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure TC packet
suppression.
Description
Show basic configurations of STP.
Show configurations of spanning
tree on the interface.
Show operation information about
the MST region.
Show configurations of the MST
region.
Description
Clear statistics about spanning
tree on the interface.
2 Ethernet
111