Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
5
Double-tagged VLAN mapping cannot be concurrently configured with basic QinQ or
tagged CVLAN/Priority-tagged VLAN mapping on the same interface. Before
configuring selective QinQ and specifying CoS of the outer VLAN, configure basic
QinQ.
2.4.6 Configuring network-side interface to Trunk mode
Configure the network-side interface to Trunk mode for the ISCOM2600G-HI series switch as
below.
Step
1
2
3
2.4.7 Configuring TPID
Configure the TPID on the network side interface for the ISCOM2600G-HI series switch as
below.
Step
1
Command
Raisecom(config-
gigaethernet1/1/port)#switchport vlan-
mapping both priority-tagged [ cos
value
] add-outer
cos-value
] [ remove | translate
id
]
Raisecom(config-
gigaethernet1/1/port)#switchport vlan-
mapping both cvlan
cos-value
[ cos
] add-outer
id
cos-value
[ cos
vlan-id
translate
Raisecom(config-
gigaethernet1/1/port)#switchport vlan-
mapping both { untag | inner
vlan-id
} add-outer
cos-value
]
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#switchport
mode trunk
Command
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
cos-
outer-vlan
id
-
[ cos
vlan-
custom
vlan-list
-
outer-vlan
] { remove |
}
inner-
outer-vlan
id
-
[ cos
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure interface trunk mode,
permit double-tagged packet to pass.
Enter global configuration mode.
Description
(Optional) configure
bidirectional selective QinQ,
and add outer VLAN rules.
The device supports this
configuration on the LAG or
in ISF mode.
-
Description
Description
2 Ethernet
78
Advertisement
Table of Contents
