Configuring Interface Loopback; Checking Configurations; Arp; Introduction - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3
4

5.2.5 Configuring interface loopback

Configure interface loopback for the ISCOM2600G-HI series switch as below.
1
2
3

5.2.6 Checking configurations

Use the following commands to check configuration results.
1

5.3 ARP

5.3.1 Introduction

In TCP/IP network environment, each host is assigned with a 32-bit IP address that is a logical
address used to identify hosts between networks. To transmit packets in physical link, you
must know the physical address of the destination host, which requires mapping the IP
address to the physical address. In Ethernet environment, the physical address is 48-bit MAC
address. The system has to transfer the 32-bit IP address of the destination host to the 48-bit
Ethernet address for transmitting packet to the destination host correctly. Then Address
Step
Raisecom(config-loopback)#ip
ip-address
address
Raisecom(config-loopback)#ipv6
ipv6-address
address
Raisecom(config-loopback)#ipv6
ipv6-address/prefix-
address
length
[ eui-64 ]
Step
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#loopback
external [cvlan
value
] svlan
value
] ] [ dmac
[ smac mac-address
mac-address
No. Command
Raisecom#show
interface loopback
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
ip-mask
[
link-local
Command
vlan-id
[ cos
vlan-id cos-
[ cos
mac-address
][ swap [smac
swap ] dmac-disable ]
Show configurations of the loopback interface.
Description
Configure the IP address of the
]
loopback interface.
Configure the IPv6 address of the
loopback interface.
Description
Enter global configuration mode.
Enter loopback interface
configuration mode.
Configure interface loopback.
cos-
]
Description
5 IP services
212