Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1
2
3
4
5
11.2.5 (Optional) configuring FS on interfaces
Configure FS on interfaces for the ISCOM2600G-HI series switch as below.
Step
1
Step
Raisecom#config
Raisecom(config)#interface
interface-type primary-
interface-number
Raisecom(config-
gigaethernet1/1/port)# port
backup
interface-type backup-
interface-number
list
Raisecom(config-port-
channel1)#port backup
type backup-interface-number
[ vlanlist
Raisecom(config-
gigaethernet1/1/port)#port
backup fault-detect lldp
Raisecom(config-
gigaethernet1/1/port)#port
backup restore-mode { non-
revertive | revertive [ restore-
second
delay
In an interface backup group, an interface is either a primary interface or a backup
interface.
In a VLAN, an interface or a LAG cannot be a member of two interface backup
groups simultaneously.
After FS is successfully configured, the primary/backup link will be switched; in
other words, the current link is switched to the backup link (without considering
Up/Down status of the primary/backup interface).
In the FS command, the backup interface number is optional. If different VLANs of
the primary interface are configured with multiple interface backup groups, you
should enter the backup interface ID.
Command
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
vlan-
vlanlist
interface-
vlan-list
]
] }
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode or LAG
configuration mode.
Configure the interface backup
group.
In the VLAN list, configure the
interface backup-interface-number
to the backup interface and
configure the interface primary-
interface-number to the primary
interface.
If no VLAN list is specified, the
VLAN ranges from 1 to 4094.
(Optional) configure LLDP fault
detection.
(Optional) configure restoration
mode.
Description
Enter global configuration mode.
11 Reliability
466
Advertisement
Table of Contents
