Figure 6-8 Automatically Obtaining Files Through Zero-Configuration - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Configure Switch A.
Step 8 Configure switches in standalone mode.

Configure GE 1/1/1 to Trunk mode, allowing packets of VLAN 10 to pass.
Configure GE 1/1/2 to Access mode, accessing packets of VLAN 10.
Raisecom#config
Raisecom(config)#create vlan 10 active
Raisecom(config)#interface gigaethernet 1/1/1
Raisecom(config-gigaethernet1/1/1)#switchport mode trunk
Raisecom(config-gigaethernet1/1/1)#switchport trunk allowed vlan 10
Raisecom(config-gigaethernet1/1/1)#interface gigaethernet 1/1/2
Raisecom(config-gigaethernet1/1/2)#switchport access vlan 10

After Switch B is powered on, it will automatically obtain the IPv6 address and download
files.
Checking results
After Switch B is powered on, you can see that it automatically obtains the IPv6 address and
download the configuration file and system files, as shown in Figure 6-8.

Figure 6-8 Automatically obtaining files through zero-configuration

Configure Switch A.
Power on Switch B.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
6 DHCP
264