Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3.5.3 Configuring ISF mode
Configure the ISF mode for the ISCOM2600G-HI series switch as below.
1
2
When the configuration command is executed, the system prompts "Set successfully.
The device will switch to single mode, take effect after reboot". To prevent the device
from being restarted, type "no", and press Enter. The device will not be restarted, so
you can further configure it.
3.6 Configuring ISF in ISF mode
3.6.1 Configuring ISF mode
Configure the ISF mode for the ISCOM2600G-HI series switch as below.
1
2
When the configuration command is executed, the system prompts "Set successfully.
The device will switch to isf mode, take effect after reboot". To prevent the device
from being restarted, type "no", and press Enter. The device will not be restarted, so
you can further configure it.
3.6.2 Configuring ISF domain ID
An ISF domain is a logical concept. Multiple devices form an ISF through ISF links, and the
set of these devices is an ISF domain. To meet requirements for different networking
applications, you can deploy multiple ISFs on a network. These ISFs are identified by ISF
domain IDs. As shown in Figure 3-9, Switch A and Switch B form ISF 1 while Switch C and
Switch D form ISF 2. If there is a MAD link between ISF 1 and ISF 2, these two ISFs send
MAD packets to each other, thus affecting their status and operation. In this case, you can
configure two different ISF domain IDs to prevent them from affecting each other.
Step
Raisecom#config
Raisecom(config)#isf-mode isf
Set successfully. The device will
switch to isf mode,take effect
after reboot
Step
Raisecom#config
Raisecom(config)#isf-mode isf
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
Command
Description
Enter global configuration mode.
Configure the ISF mode.
Description
Enter global configuration mode.
Configure the ISF mode.
3 ISF
167
Advertisement
Table of Contents
