Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
3
4
5
6
7
You can configure RIP version globally and on the interface of the iTN8800. If the
interface is configured with RIP version, then this RIP version prevails.
5.6.4 Redistributing external routes
Redistribute external routes for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
Command
Raisecom(config-
version-id
rip)#version
Raisecom(config-rip)#exit
Raisecom(config)#interface
interface-type interface-
number
Raisecom(config-vlan1)#ip
rip receive version { 1 |
2 }*
Raisecom(config-vlan1)#ip
rip send version { 1 |
2 } *
Raisecom(config-vlan1)#ip
rip v2-broadcast
Command
Raisecom#config
Raisecom(config)#router
rip
Raisecom(config-
rip)#host-route
Raisecom(config-
rip)#default-information
originate
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Configure global RIP version ID.
By default, global RIP version is not
configured. In this case, interfaces which are
configured with RIP but not configured with
the RIP version in the Tx direction will send
V1 packets. Interfaces which are enabled with
RIP but not configured with the RIP version
in the Rx direction will receive packets of any
version.
Enter interface configuration mode.
Configure the receiving RIP version.
By default, the receiving RIP version is
subjected to the global RIP version.
Configure the sending RIP version.
By default, the sending RIP version is
subjected to the global RIP version.
Configure the interface which runs RIPv2 to
send broadcast updates.
By default, it sends multicast updates.
Description
Enter global configuration mode.
Enable RIP, and enter RIP configuration
mode.
Enable the function of receiving host routes.
By default, it is enabled.
Enable broadcasting the default route.
By default, it is disabled.
5 IP services
227
Advertisement
Table of Contents
