Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Configuring redistributed external route aggregation
After the external route is redistributed, configure route aggregation on the ASBR. The
ISCOM2600G-HI series switch just puts the aggregated route on the ASE LSA. This helps
reduces the number of LSAs in the LSDB.
Configure inter-area route aggregation for the ISCOM2600G-HI series switch as below.
1
2
3
Configuring default route redistribution
Configure default route redistribution for the ISCOM2600G-HI series switch as below.
1
2
3
5.7.10 Configuring OSPF routing policy
Configuring OSPF receiving policy
Configure the OSPF receiving policy for the ISCOM2600G-HI series switch as below.
1
Step
Command
Raisecom#config
Raisecom(config)#router
process-id
ospf
[ router-id
Raisecom(config-router-
ospf)#summary-address
ip-address ip-mask
[ not-advertise ]
metric
[ metric
Step
Command
Raisecom#config
Raisecom(config)#router
ospf
process-id
[ router-id
Raisecom(config-router-
ospf)#default-
information originate
[ always ] [ metric
metric
] [ type { 1 |
2 } ]
Step
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enable an OSPF process and enter OSPF
configuration mode.
router-id
]
Aggregate external routes.
By default, external routes are not aggregated.
When external aggregates are aggregated, the
Metric is the maximum Metric of the LSA by
]
default.
Enter global configuration mode.
Enable an OSPF process and enter OSPF
configuration mode.
router-id
]
Redistribute the default route.
By default, no default route is generated. When the
default LSA is generated, if the always key word is
specified, the default Metric is 1. If the always key
word is not specified, the Metric is 10.
Command
Description
Description
Description
Enter global configuration mode.
5 IP services
246
Advertisement
Table of Contents
