Configuring Mld Querier - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3
4
5

8.8.6 Configuring MLD Querier

Configure MLD Querier for the ISCOM2600G-HI series switch as below.
1
2
3
4
5
6
7
8


Step
Raisecom(config)#mld snooping vlan
vlan-list
Raisecom(config)#vlan
Raisecom(config-vlan)#mld snooping
static ip-address
interface-number
Raisecom(config)#interface
interface-type interface number
Raisecom(config-
gigaethernet1/1/1)#mld snooping
group-address
Step Command
Raisecom#config
Raisecom(config)#mld
querier
Raisecom(config)#mld
ip-address
source-ip
Raisecom(config)#mld
query-interval
Raisecom(config)#mld
query-max-response-time
seconds
Raisecom(config)#mld
last-member-query
seconds
interval
Raisecom(config)#mld
robust-count
Raisecom(config)#mld
proxy
When IGMP Querier is disabled, the following parameters can be configured:
source IP address, query interval, maximum response time to send Query packets,
and interval for the last member to send Query packets. After IGMP Querier is
enabled, these configurations will take effect immediately.
MLD proxy and MLD Querier are mutually exclusive. MLD proxy and MLD report-
suppression are mutually exclusive.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
vlan-id
[ interface-type
]
vlan-id
vlan
Enter global configuration mode.
Enable MLD querier.
(Optional) configure the source IP address for
MLD Querier to send Query packets.
(Optional) configure the MLD query interval.
seconds
(Optional) configure the maximum response
time of Query packets.
(Optional) configure the interval for the last
-
member to send Query packets.
Configure the robustness factor of MLD.
value
Enable MLD Proxy.
Description
(Optional) enable MLD
Snooping in all VLANs.
(Optional) configure the static
member of MLD Snooping in
VLAN mode.
(Optional) configure the host
joining function for MLD
Snooping on the interface.
Description
8 Multicast
358