Checking Configuration; Example For Configuring Pvlan - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
8
9

2.3.7 Checking configuration

Use the following commands to check configuration results.
1
2
3

2.3.8 Example for configuring PVLAN

Networking requirements
To effectively distribute VLAN resources, you need to properly partition and configure
VLANs. As shown in Figure 2-5, on Switch A, configure VLAN 10 as the primary VLAN,
VLAN 20 as the isolated VLAN, and VLAN 30 as the community VLAN. The detailed
configurations are as below:




Command
Raisecom(config-
gigaethernet1/1/1)#switchport
private-vlan mapping
vlan-id
[ add | remove ]
secondary-vlan-list
Raisecom(config-
port)#switchport private-vlan
trunk mapping
No.
Raisecom#show vlan private-vlan
Raisecom#show switchport interface
interface-type interface-number
Raisecom#show vlan [
static | dynamic ] [ detail ]
Configure GE 1/1/1 and GE 1/1/2 as community interfaces. Associate primary VLAN 10
with secondary VLAN 30.
Configure GE 1/1/3 and GE 1/1/4 as isolated interfaces. Associate primary VLAN 10
with secondary VLAN 20.
Configure GE 1/1/5 as the promiscuous interface. Map PVLAN with VLAN 10, VLAN
20, and VLAN 30.
Connect PC 1 and PC 2 to community interfaces GE 1/1/1 and GE 1/1/2 respectively,
and they can communicate with these two interfaces and the promiscuous interface GE
1/1/1.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
primary-
primary-vlan-id
Command
vlan-list
|
Description
Configure the mapping of the primary
VLAN and secondary VLANs on the
promiscuous interface.
Use the no switchport private-vlan
mapping command to delete the
association between the primary VLAN
of the promiscuous interface with the
secondary VLAN.
Configure the interface mapped with the
primary VLAN to be able to forward
tagged packets.
Use the no switchport private-vlan
trunk mapping command to delete this
configuration.
Description
Show PVLAN configuration.
Show configuration of
interface VLAN attributes.
Show configuration of
VLAN attributes.
2 Ethernet
71