Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Configure Switch A to ISF mode.
Raisecom#config
Raisecom(config)#isf mode isf
next unit is: 9, please input 'yes':yes
This configuration will go into effect after reboot, Please input 'yes'
to reboot:yes
Will you change start-config ? please input 'yes' to change:yes
1970-01-01,08:06:46 System-4-SYSTEM_REBOOT:unit1: Change work Mode
reboot !
Operation successfully
Raisecom(config)#
BOOTROM starting ..
After Switch A is restarted, it forms an ISF that has only one member device.
Configure the member ID to 2 and member priority to 26. Create ISF interface 1. Bind it with
the physical interface Tengigabitethernet 1/1/25.
Raisecom#config
Raisecom(config)#isf renumber 2
Member ID change will take effect after the switch reboots and work in
ISF mode
Will you change start-config ? please input 'yes' to change:no
Raisecom(config)#isf priority 26
Raisecom(config)#interface tengigabitethernet 1/1/25
Raisecom(config)#interface isf-port 1/1/1
Raisecom(config-isf-port1/1/1)#isf port-group tengigabitethernet 1/1/25
Raisecom(config)#exit
Save running configurations to the startup configuration file.
Raisecom#write
Configure Switch B to ISF mode.
Raisecom#config
Raisecom(config)#isf mode isf
next unit is: 2, are you sure ? please input 'yes':yes
This config reboot go into effect, Please input 'yes' to reboot:yes
Will you change start-config ? please input 'yes' to change:yes
Configure Switch B.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
3 ISF
180
Advertisement
Table of Contents
