Checking Configurations; Mld; Introduction - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Table of Contents

Advertisement

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2
3

8.7.7 Checking configurations

Use the following commands to check configuration results.
1
2
3
4
5
6

8.8 MLD

8.8.1 Introduction

MLD is a network protocol used in multicast technologies. Through MLD, a router can snoop
whether there is a snooper of the IPv6 multicast group in the connected network segment, and
then record the result in the database. The router also maintains timer information about these
IPv6 multicast addresses. Through MLD, the user host and the expected directly-connected
multicast router establish and maintain multicast membership.
A MLD router uses the local address of IPv6 unicast link as the source address to send MLD
packets, and uses ICMPv6 packets. All MLD packets are limited to local links, with hops of 1.
The ISCOM2600G-HI series switch supports two MLD versions:
Step
Command
Raisecom(config)#interface
interface-type interface-
number
Raisecom(config-
gigaethernet1/1/port)#igmp
vlan-copy user-vlan
No.
Command
Raisecom#show igmp vlan-
copy
Raisecom#show igmp vlan-
interface-type
copy
interface-number
Raisecom#show igmp vlan-
copy member
Raisecom#show igmp vlan-
copy member
type interface-number
Raisecom#show igmp vlan-
copy member user-vlan
vlan-id
Raisecom#show igmp vlan-
copy vlan-group [ mcast-
vlan-id
vlan
MLDv1: defined by RFC2710, derived from IGMPv2
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
vlan-id
Show configurations of multicast VLAN
copy.
Show configurations of multicast VLAN
copy on the specified interface.
Show information about multicast group
members of multicast VLAN copy.
Show information about multicast group
interface-
members of multicast VLAN copy on the
specified interface.
Show information about multicast group
members of multicast VLAN copy in the
specified user VLAN.
Show the multicast VLAN and bound group
address set of multicast VLAN copy.
]
Description
Enter physical layer interface
configuration mode.
Configure the customer VLAN of
multicast VLAN copy.
Description
8 Multicast
355

Advertisement

Table of Contents
loading

Table of Contents