Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1.6.7 Configuring SNTP
Configuring unicast feature of SNTP client
Configure unicast feature of SNTP client for the ISCOM2600G-HI series switch as below.
Step
1
2
1.6.8 Checking configurations
Use the following commands to check configuration results.
No.
1
2
3
4
5
1.6.9 Example for configuring NTP
Networking requirements
Establish a clock synchronization system in a company to keep consistency and precision of
the system time. Basic planning is as below:
Command
Raisecom#config
Raisecom(config
)#sntp server
ipv4-address
{
ipv6-
|
address
}
Command
Raisecom#show clock
[ summer-time-recurring ]
Raisecom#show sntp
Raisecom#show ntp status
Raisecom#show ntp
associations [ detail ]
Raisecom#show ntp
authentication
Configure Switch A as the master clock source of the clock synchronization system.
Configure Switch B as the client of the clock synchronization system. Configure the
upper-layer Switch A as the NTP server.
Configure Switch C as the NTP entity of Switch B so that Switch C receives downlink
synchronization data from Switch B.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Enter global configuration mode.
Configure the IP address of the SNTP unicast server.
After the SNTP server is configured with an IP address,
the ISCOM2600G-HI series switch tries to get the clock
information from the SNTP server every 10s. In addition,
the maximum timeout is 60s.
Show configurations of the time zone and
DST.
Show SNTP configurations.
Show NTP configurations.
Show information about NTP connection.
Show information about NTP identity
authentication.
1 Basic configurations
Description
36
Advertisement
Table of Contents
