Optional) Creating G.8032 Tributary Ring - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step

4.1.6 (Optional) creating G.8032 tributary ring






Configure G.8032 intersecting rings for ISCOM2600G-HI series switch as below.
Step
1
2
Raisecom(config)# ethernet ring-
ring-id
protection
failure-detect physical-link-or-cc
md-name
[ md
level local
mep
Only the intersecting ring consists of a main ring and a tributary ring.
Configurations of the main ring are identical to those of the single/tangent ring. For
details, see section 4.1.4 Creating G.8032 ring.
For the intersecting ring, configure its main ring and then the tributary ring.
Otherwise, the tributary ring will fail to find the interface of the main ring, thus
failing to establish the virtual channel of the tributary ring.
The ID of the tributary ring must be greater than that of the main ring.
Configurations of non-intersecting nodes of the intersecting ring are identical to
those of the single/tangent ring. For details, see section 4.1.4 Creating G.8032
ring.
Command
Raisecom#config
Raisecom(config)#ethernet
ring-protection
{ east | west }
{ interface-type
interface-number
port-channel-
channel
number
} node-type rpl-
owner [ not-revertive ]
[ protocol-vlan
[ block-vlanlist
list
]
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
{ east | west }
ma-name
] ma level
mep-id remote mep-id
- -
Enter global configuration mode.
Create the tributary ring on the intersecting
ring-id
node and configure the intersecting node as the
RPL Owner.
The protection ring is in non-revertive mode if
| port-
you configure the non-revertive parameter.
 In revertive mode, when the working line
recovers from a fault, traffic is switched from
vlan-id ] the protection line to the working line.
vlan-  In non-revertive mode, when the working line
recovers from a fault, traffic is not switched
from the protection line to the working line.
By default, the protection ring is in revertive
mode.
The links between 2 intersecting nodes
belong to the main ring. Therefore, when
you configure the tributary ring on the
intersecting node, you can only configure
the west or east interface.
4 Ring network protection
Description
Configure the ERPS fault
detection mode to physical link
or CC. In other words, the fault
detected by physical link or CC
is reported.
Description
196