Configuring Igmp Querier - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
IGMP Querier status
IGMP packet suppression status
Source IP address for IGMP Querier to send
packets
IGMP query interval
Maximum response time to send Query packets
Interval for the last member to send Query packets

8.4.4 Configuring IGMP Querier

Configure IGMP Querier for the ISCOM2600G-HI series switch as below.
1
2
3
4
5
6
7



Function
Step Command
Raisecom#config
Raisecom(config)#igmp
querier
Raisecom(config)#igmp
ip-address
source-ip
Raisecom(config)#igmp
querier query-
seconds
interval
Raisecom(config)#igmp
querier query-max-
response-time
Raisecom(config)#igmp
querier last-member-
query-interval
seconds
Raisecom(config)#igmp
proxy
When IGMP Querier is disabled, the following parameters can be configured:
source IP address, query interval, maximum response time to send Query packets,
and interval for the last member to send Query packets. After IGMP Querier is
enabled, these configurations will take effect immediately.
Though IGMP Snooping or IGMP MVR is enabled, IGMP Querier can be still
enabled.
IGMP Proxy and IGMP Querier are mutually exclusive. IGMP Proxy and IGMP
report suppression are mutually exclusive.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enable IGMP Querier.
(Optional) configure the source IP address for the
IGMP querier to send Query packets.
(Optional) configure the IGMP query interval.
(Optional) configure the maximum response time
to send Query packets.
seconds
(Optional) configure the interval for the last
member to send Query packets.
Configure IGMP proxy.
Default value
Disable
Disable
Use the IP address of IP address 0.
If IP interface 0 is not configured,
use 0.0.0.0.
125s
10s
1s
Description
8 Multicast
337