Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3
10.3.5 Configuring static binding of dynamic ARP inspection
Configure static binding of dynamic ARP inspection for the ISCOM2600G-HI series switch
as below.
1
2
3
10.3.6 Configuring dynamic binding of dynamic ARP inspection
Before enabling dynamic binding of dynamic ARP inspection, you need to use the ip
dhcp snooping command to enable DHCP Snooping.
Configure dynamic binding of dynamic ARP inspection for the ISCOM2600G-HI series
switch as below.
1
2
10.3.7 Configuring protection VLAN of dynamic ARP inspection
Configure protection VLAN of dynamic ARP inspection for the ISCOM2600G-HI series
switch as below.
1
Step
Command
Raisecom(config-
gigaethernet1/1/port)#ip
arp-inspection trust
Step
Raisecom#config
Raisecom(config)#ip arp-inspection
static-config
Raisecom(config)#ip arp-inspection
ip-address mask
binding
address
] [ vlan
interface-type interface-number
Step
Command
Raisecom#config
Raisecom(config)#ip arp-
inspection dhcp-snooping
Step
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Configure the interface as a trusted
interface. Use the no ip arp-inspection
trust command to configure the interface to
an untrusted interface; in other words, the
interface does not trust the ARP packet.
Command
mac-
[
vlan-id
]
Command
Description
Description
Enter global configuration mode.
Enable global static ARP
binding.
Configure the static binding.
Description
Enter global configuration mode.
Enable global dynamic ARP binding.
Description
Enter global configuration mode.
10 Security
413
Advertisement
Table of Contents
