Configuring Static Lacp Link Aggregation - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
4
5

11.1.4 Configuring static LACP link aggregation

Configure static LACP link aggregation for the ISCOM2600G-HI series switch as below.
1
2
3
4
5
6
7
Step Command
Raisecom(config-port-
channel1)#{ max-active |
min-active } links
threshold
Raisecom(config-port-
channel1)#load-sharing mode
{ dst-ip | dst-mac | src-
dst-ip | src-dst-mac | src-
ip | src-mac }
Step Command
Raisecom#config
Raisecom(config)#lacp
system-priority
system-priority
Raisecom(config)#lacp
timeout { fast |
slow }
Raisecom(config)#inte
rface port-channel
channel-number
Raisecom(config-port-
channel1)#mode lacp
Raisecom(config-port-
channel1)#{ max-
active | min-active }
value threshold
links
Raisecom(config-port-
channel1)#lacp
priority preempt
enable
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
(Optional) configure the maximum or
minimum number of active links in
value
LACP LAG.
By default, the maximum number is 8
while the minimum is 1.
(Optional) configure a load balancing
mode for link aggregation.
By default, the load balancing algorithm
is configured to sxordmac. In this mode,
select a forwarding interface based on the
OR result of the source and destination
MAC addresses.
Enter global configuration mode.
(Optional) configure the system LACP priority.
The device with higher priority is the active end.
LACP chooses active and backup interfaces
according to configurations of the active end.
The smaller the number is, the higher the priority
is. The device with the smaller MAC address will
be chosen as the active end if system LACP
priorities of the two devices are identical.
By default, the system LACP priority is 32768.
(Optional) configure LACP timeout mode.
By default, it is slow.
Enter LAG configuration mode.
Configure the working mode of the LAG to static
LACP LAG.
(Optional) configure maximum or minimum
number of active links in LACP LAG.
By default, the maximum number is 8 while the
minimum number is 1.
Enable priority preempt on the LAG.
11 Reliability
Description
Description
458