Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2.14.5 Configuring GVRP
Configure GVRP for the ISCOM2600G-HI series switch as below.
1
2
3
4
5
6
2.14.6 Checking configurations
Use the following commands to check configuration results.
1
2
3
4
5
Step
Raisecom#config
Raisecom(config)#gvrp enable
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#switchport
mode trunk
Raisecom(config-
gigaethernet1/1/port)#gvrp
registration { fixed | forbidden |
normal }
Raisecom(config-
gigaethernet1/1/port)#gvrp enable
Interface GVRP can be enabled only after the interface is configured to Trunk
mode.
We do not recommend enabling GVRP on a LAG member interface.
No.
Raisecom#show garp [
type interface-number
Raisecom#show garp [
type interface-number
Raisecom#show gvrp [
type interface-number
Raisecom#show gvrp [
type interface-number
Raisecom#show gvrp local-vlan
interface-type interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
Command
interface-
]
interface-
] statistics
interface-
]
interface-
] statistics
Description
Enter global configuration mode.
Enable global GVRP.
Enter physical layer interface
configuration mode.
Configure the interface to Trunk
mode.
(Optional) configure GVRP
registration mode.
Enabling interface GVRP.
Description
Show configurations of the
GARP timer.
Show GARP statistics.
Show GVRP configurations.
Show GVRP statistics.
Show the local VLAN of GMRP.
2 Ethernet
148
Advertisement
Table of Contents
