Configuring Snmp Interface - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
2
3

1.7.8 Configuring SNMP interface

By default, the IP address of the SNMP interface is 192.168.0.1 and the subnet mask
is 255.255.255.0.
Configure the SNMP interface for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
5
6
7
Command
Raisecom(config)#co
nsole open
Raisecom(config)#lo
gin-trap enable
Command
Raisecom#config
Raisecom(config)#interface
fastethernet 1/0/1
Raisecom(config-
fastethernet1/0/1)#ip address
address ip-mask
[
Raisecom(config-
fastethernet1/0/1)#ipv6 address
ipv6-address/prefix-length
Raisecom(config-
fastethernet1/0/1)#ipv6 address
ipv6-address
link-local
Raisecom(config-
fastethernet1/0/1)#ip dhcp server
Raisecom(config-
fastethernet1/0/1)#ip dhcp client
class-id
{ class-id
client-id
| hostname
Raisecom(config-
fastethernet1/0/1)#ip dhcp client
renew
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
(Optional) enable the Console interface.
Use this command in non-Console command lines
only.
If you use the console close command to
disable the Console interface, this will cause
the ISCOM2600G-HI series switch to be out of
control. Use it with caution.
(Optional) enable Trap sending upon user login or
exit.
ip-
]
[ eui-64]
| client-id
hostname
}
1 Basic configurations
Description
Description
Enter global configuration mode.
Enter SNMP interface
configuration mode. The device
supports shutdown.
Configure the IPv4 address of
the SNMP interface.
Configure the IPv6 address of
the SNMP interface.
(Optional) enable DHCP Server
on the SNMP interface.
(Optional) configure information
about the DHCP client on the
SNMP interface, including the
class ID, client ID, and host
name.
(Optional) configure the IP
address to be renewed for the
SNMP interface.
43