Preparing For Configurations; Default Configurations Of Lldp; Enabling Global Lldp - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide


12.3.2 Preparing for configurations

Scenario
When you obtain connection information between devices through NView NNM system for
topology discovery, the ISCOM2600G-HI series switch needs to enable LLDP, notify their
information to the neighbours mutually, and store neighbour information to facilitate the
NView NNM system queries.
Prerequisite
N/A

12.3.3 Default configurations of LLDP

Default configurations of LLDP are as below.
Global LLDP
LLDP interface status
Delay timer
Period timer
Aging coefficient
Restart timer
Alarm function
Alarm notification timer
Destination MAC address of LLDP packets

12.3.4 Enabling global LLDP

After global LLDP is disabled, you cannot re-enable it immediately. Global LLDP
cannot be enabled unless the restart timer times out.
When you obtain connection information between devices through the NView NNM system
for topology discovery, the ISCOM2600G-HI series switch needs to enable LLDP, sends their
information to the neighbours mutually, and stores neighbour information to facilitate query
by the NView NNM system.
Enable global LLDP for the ISCOM2600G-HI series switch as below.
Hold-multiplier refers to the aging coefficient of device information in neighbor node.
Function
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
12 System management
Default value
Disable
Enable
2s
30s
4
2s
Enable
5s
0180.c200.000e
503