Default Configurations Of Zero-Configuration; Preparing For Configuration; Figure 6-5 Zero-Configuration Server Networking - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

Figure 6-5 Zero-configuration server networking

By default, zero-configuration is enabled on the device. To disable it, configure the
device to common client mode.

6.2.2 Default configurations of zero-configuration

Default configurations of zero-configuration are as below.
Zero-configuration polling period
Zero-configuration mode

6.2.3 Preparing for configuration

Scenario
To enable the remote device to automatically apply for the IP address after being powered on,
configure zero-configuration. To configure zero-configuration parameters, see the following
section.
Prerequisite

Function
Connect the device to the DHCP server correctly. Configure the DHCP server correctly.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Default value
2h
Enable
6 DHCP
259