Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
3
Command
Raisecom(config)#ethernet
ring-id
ring-protection
{ east | west }
interface-type
{
interface-number
| port-
port-channel-
channel
number
} node-type rpl-
neighbour [ not-
revertive ] [ protocol-
vlan-id
vlan
] [ block-
vlan-list
vlanlist
Raisecom(config)#ethernet
ring-protection
ring-id
{ east | west }
interface-type
{
interface-number
| port-
channel
port-channel-
number
} [ not-
revertive ] [ protocol-
vlan-id
vlan
] [ block-
vlan-list
vlanlist
Raisecom(config)#ethernet
ring-protection
ring-id
raps-vc { with |
without }
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Create the tributary ring on the intersecting
node and configure the intersecting node as the
RPL Neighbour.
]
Create the tributary ring on the intersecting
node and configure the intersecting node as the
protection forwarding node.
]
(Optional) configure the tributary ring virtual
channel mode on the intersecting node.
Because the intersecting node belongs to the
main ring, transmission modes of protocol
packets in the tributary ring are different from
the ones of the main ring. In the tributary ring,
transmission modes are divided into with and
without modes.
with: the main ring provides channels for
APS packets of the tributary ring; the
tributary ring intersecting node transmits APS
packets of the tributary ring to the main ring
to use the main ring to complete
communications among intersecting nodes of
the tributary ring.
without: APS packets of the tributary ring on
intersecting nodes need to be ended and
cannot be transmitted to the main ring. This
mode requires the tributary ring not to block
the protocol VLAN of the tributary ring (to
ensure tributary ring packets to traverse
Owner).
By default, the virtual channel of the tributary
ring adopts the with mode. Transmission
modes on 2 intersecting nodes must be
identical.
4 Ring network protection
Description
197
Advertisement
Table of Contents
