Leds; Table 2-15 Configuring Triggering Condition; Table 2-16 Parameters Of The Di Interface; Table 2-17 Leds - Raisecom Gazelle S1020i-GL Series User Manual

Raisecom
Gazelle S1020i-GL (A) User Manual

Table 2-15 Configuring triggering condition

1
2
Table 2-16 lists parameters of the DI interface.

Table 2-16 Parameters of the DI interface

Connector type
Input voltage range
High level
Low level
Maximum input current

2.4 LEDs

Table 2-17 lists LEDs on the Gazelle S1020i-GL, which are located at the line side on the
front panel. Lights are guided to the front panel through light pipes.

Table 2-17 LEDs

DC power status
LED
System status
LED
Step Command
Raisecom#config
Raisecom(config
)#alarm
outside-alarm
num
{ high |
low }
Parameter
LED Print

PWR1

PWR2
SYS
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Configure the triggering condition of an external alarm
to high level or low level.
 Num: being 1 or 2, DI ID
 High: configure the triggering condition to high level.
 Low: configure the triggering condition to low level.
By default, each external alarm is triggered by
high level.
5.08 mm × 5-pin Phoenix connector
-30 to +30 VDC
13–30 VDC
-30 to +1 VDC
8 mA
Status

Green: the power supply is normal.
Green

Off: the power supply is abnormal or off.

Green: the system is being started or
Green
working improperly.
 Blinking green: the system is working
properly.
 Off: the system is being started or working
improperly.
2 Hardware structure
Description
Description
Description
25