Wiring; Ethernet Cable; Introduction; Figure 3-3 Fc/Pc Fiber Connector - Raisecom ISCOM5504-GP Hardware Description

Raisecom
ISCOM5504-GP (A) Hardware Description

Figure 3-3 FC/PC fiber connector

When connecting or removing the FC/PC fiber connector, align the connector with the optical
interface, and do not rotate the fiber. Operate as below:



3.1.3 Wiring

Table 3-3 lists the wiring of the fiber.

Table 3-3 Wiring of the fiber

Single-fiber
connection
Dual-fiber
connection

3.2 Ethernet cable

3.2.1 Introduction

The Ethernet cable of the ISCOM5504-GP can be used to:


To connect the fiber, align the fiber head with the optical interface. Be careful not to
damage the ceramic tube inside the optical interface. After snapping the fiber in place,
rotate the screw sleeve clockwise to secure the optical interface.
To remove the fiber, rotate the screw sleeve counterclockwise. When the screw sleeve is
loosened, pull the fiber out.
Wiring Local optical interface
Optical interface
Optical interface Tx
Optical interface Rx
Connect the Ethernet electrical interface of the ISCOM5504-GP to other devices.
Connect the SNMP of the ISCOM5504-GP to the NMS.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Direction of Peer optical interface
optical signals
<-> Optical interface
-> Optical interface Rx
<- Optical interface Tx
3 Fiber and cables
19