Installing And Removing Line Cards, Plims, And Associated Components; About Installing And Removing Cards And Associated Components; Guidelines For Card Installation And Removal - Cisco SRS Series Installation Manual

Installing and Removing Line Cards, PLIMs, and
Associated Components
This chapter provides instructions on how to install and remove the Cisco CRS Carrier Routing System 16-Slot
Line Card Chassis (LCC) cards, physical layer interface modules (PLIMs), and any associated components.
Note For CRS-X next generation line cards and fabric cards, we recommend that you use a modular configuration
power system in the chassis.
•
•
•
•
•
•
•
•
•
•
•
•
•
About Installing and Removing Cards and Associated
Components
This section contains some general information about installing and removing cards, PLIMs, and associated
components.

Guidelines for Card Installation and Removal

Guidelines for card installation and removal include the following:
About Installing and Removing Cards and Associated Components, on page 105
Installing or Removing a Slot Cover, on page 113
Installing or Removing an Impedance Carrier, on page 115
Installing or Removing a Pillow Block, on page 118
Installing or Removing a Switch Fabric Card, on page 122
Installing or Removing a Line Card, on page 130
Installing or Removing the LCC Fan Controller Card, on page 138
Installing or Removing an RP, PRP, or DRP PLIM, on page 144
Installing or Removing a PLIM, on page 153
Installing or Removing a Card-Based Hard Drive, on page 161
Installing or Removing a PCMCIA Card, on page 163
Installing or Removing Optical Modules, on page 166
Installing or Removing a Cable Management Bracket, on page 166
C H A P T E R
Cisco CRS Routers 16-Slot Line Card Chassis Installation Guide
4
105