Installing An I/O Card In The Cisco Asa 5512-X, 5515-X, And 5525-X Chassis; Replacing The Chassis Cover; Working In An Esd Environment - Cisco ASA5500-HW - Hardware Accessory Kit Network Device Hardware Installation Manual

Chapter 4 Maintenance and Upgrade Procedures
Figure 4-2
1
Reinstall the chassis on a rack.
Step 3
Reinstall the network interface cables.
Step 4
Power on the chassis.
Step 5
Installing an I/O Card in the Cisco ASA 5512-X, 5515-X, and
5525-X Chassis
To remove an existing I/O card and install a new one, perform the following steps:
Power off the chassis, remove the power cable from the chassis, and remove the chassis from the rack.
Step 1
Locate a grounding strap, and fasten it to your wrist so that it contacts bare skin. Attach the other end to
Step 2
the chassis. See the
With a Phillips head screwdriver, loosen the captive installation screw on the rear of the chassis
Step 3
Remove the chassis cover by placing your hand on top of the chassis lid, pressing down firmly, and
Step 4
pushing the cover toward the rear of the chassis.
Determine the location of the I/O card. (See
Step 5

Replacing the Chassis Cover

1
Thumbscrew
"Working in an ESD Environment" section on page 2-3

Installing an I/O Card in the Cisco ASA 5512-X, 5515-X, and 5525-X Chassis

Figure 4-3.)
Cisco ASA 5500-X Series Hardware Installation Guide
for more information.
4-3