About Line Cards - Cisco NCS 1004 Hardware Installation Manual

Install Cisco NCS 1004 Modules
This chapter contains procedures to install the modules of Cisco NCS 1004.
Caution All the modular slots in the NCS 1004 chassis should always be populated with respective modules (line-cards,
controller, PSU & fan units). Empty line card slots to be populated with filler modules, which are shipped
with the chassis. The replacement or upgrade of the modules (Online Insertion or Removal, OIR) to be
performed only when the ambient temperature is below 30-degree C. The OIR of modules should be completed
within five minutes to prevent overheating of the components.
•
•
•
•
•
•
•
•

About Line Cards

The Cisco NCS 1004 supports the following line cards:
• 1.2T DWDM Line Card
About Line Cards, on page 39
Install Power Supply, on page 41
Install Controller , on page 46
Install Fan Unit, on page 46
Attach Fiber Management Bracket, on page 48
Adjust Fiber Management Bracket of the 1.2T Line Card, on page 48
Install Pluggables, on page 50
Air Filter, on page 52
5
C H A P T E R
Hardware Installation Guide for Cisco NCS 1004
39