Rep 10.3 Duplex Solenoid Assembly And Duplex Gate - Xerox WorkCentre 4150 Service Manual

REP 10.3 Duplex Solenoid Assembly and Duplex Gate

Parts List on PL 10.15
Removal
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions,
1. Remove the Exit Assembly (REP 10.2).
2. Remove the Support Bracket (Figure
NOTE: When the Support Bracket is removed, the back of the Duplex Gate will be
released.
2
Remove the 4 E-clips
and the 4 bearings.
Duplex Gate
(see NOTE)
Figure 1 Removing the Support Bracket
WorkCentre 4150/4250/4260WorkCentre WorkCentre 4150/4250/42604150/
WARNING
WARNING
CAUTION
GP
1).
1
Remove the
3 gears.
3
Remove 3 screws marked A.
4
Route the wire harness out of the
Bracket and remove the Bracket.
Take care when releasing the front of the duplex gate. The clip is easily broken.
3. Remove the Duplex Gate and Exit Assembly Upper Guide
10.
1
Release the front of
the duplex gate (see
CAUTION).
Figure 2 Removing the Duplex Gate and Exit Assembly Upper Guide
January 2016
4-149
CAUTION
(Figure 2).
2
Remove 4 screws.
3
Move the exit assembly
upper guide to expose
the duplex solenoid.
Repairs and Adjustments
REP 10.3