Rep 8.32 Duplex Sensor - Xerox WorkCentre 5790 Series Service Manual

Replacement
The replacement is the reverse of the removal procedure. Refer to
screws.
1. Install the tray 3 and tray 4 transport roll,
2
Press and slide the shaft
Front bearing.
into the front bearing.
Figure 4 Install the transport roll
2. (35-55 ppm Only) Ensure that the ground plate has contact with the transport roll shaft,
refer to Figure 1.
3. If a new tray 3 and tray 4 transport roll is installed, reset the tray 3 / 4 trans count to zero
in the HFSI feature screen. Refer to
Repairs/Adjustments
REP 8.31, REP 8.32
GP 6 before refitting the
Figure 4
1
Locate the shaft in the
bearing at the rear.
GP 17 High Frequency service Items.

REP 8.32 Duplex Sensor

Parts List on (35-55 ppm)
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Take care during this procedure. Motors will become hot during normal operation.
1. Remove the duplex transport,
NOTE: The duct on the duplex transport is only on the 65 - 90 ppm machine.
2. Identify the speed of the machine and go to the appropriate procedure:
a. (35-55 ppm). Remove the duplex sensor,
1
Disconnect the harness.
Figure 1 Duplex sensor (35-55 ppm)
May 2013
4-154
PL 8.22, (65-90 ppm) PL 8.20
WARNING
GP 14. Disconnect the power cord from the
WARNING
WARNING
REP 8.7.
Figure 1.
2
Press the lugs to
release the sensor.
3
Remove the sensor.
Xerox® WorkCentre® 5790 Family