REP 10.6.2 STM Takeaway Motor
Parts List on
PL 10.6
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
Static electricity may damage electrical parts.
Static electricity may damage electrical parts. Always wear a wrist band during servicing. If a
wrist band is not available, touch some metallic parts before servicing to discharge the static
electricity.
1.
Remove the Docking Bracket (x2). (Figure 1)
(1) Remove the Docking Screw (x2).
(2) Remove the Docking Bracket (x2).
Figure 1 j0lj41003
2.
Remove the Rear Cover of the One Tray Module. (Figure 2)
(1) Remove the screw (x2).
(2) Remove the Rear Cover.
Repairs and Adjustments
REP 10.6.2
WARNING
CAUTION
3.
Remove the STM Takeaway Motor. (Figure 3)
(1) Disconnect the connector.
(2) Remove the screw (x2).
(3) Remove the STM Takeaway Motor.
Replacement
1.
To install, carry out the removal steps in reverse order.
08/2012
4-36
Figure 2 j0lj41004
Figure 3 j0xh41010
WorkCentre 5021/5019
Initial Issue