Rep 8.5 Mea Unit - Feed Roller Assembly - Xerox WorkCentre M20 Service Manual

5. Remove the ELA HOU - MP assembly, Figure 4.
Figure 4 ELA HOU - MP assembly removal
Replacement
Replacement is the reverse of the removal procedure.
Repairs and Adjustments
REP 8.4, REP 8.5

REP 8.5 MEA Unit - Feed Roller Assembly

Parts List on PL 8.15
3
Removal
Remove the ELA HOU -
MP assembly.
Switch off the electricity to the machine. Disconnect the power cord from the customer
1 supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Release the harness.
Take care during this procedure. Sharp edges may be present that can cause injury.
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
NOTE: If necessary, refer to GP 20 for the acronym list and cross reference lists of more com-
2
monly recognised part names.
Unclip the ELA HOU - MP
1. Remove the ELA HOU - MP assembly, REP 8.4.
assembly by releasing the
2. Pull out the tray 1 cassette assembly approximately 100mm (4 inches).
two clips from under the
machine.
3. Prepare to remove the MEA unit - feed roller assembly, Figure 1.
December 2006
4-44
WARNING
WARNING
CAUTION
1
Remove 3 screws.
Figure 1 Preparation
WorkCentre M20, 4118, FaxCentre 2218 Family