Rep 80.15 Tray 2 Feed/Retard/Nudger Roll (Stm); Rep 80.16 Bypass Tray Nudger/Feed Roll - Xerox VersaLink B7025 Service Manual

REP 80.15 Tray 2 Feed/Retard/Nudger Roll (STM)

Parts List on PL 80.25
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
NOTE: New feed, retard and nudger rolls must be installed at the same time.
1. Pull out tray 1 and tray 2. Remove the paper.
2. Remove tray 1 and tray 2.
3. Open the left cover assembly, PL 70.25 Item
4. Remove the tray 2 feed, retard and nudger rolls (1TM),
a. Slide the chute (1) forwards.
b. Release the clip, then remove the tray 2 feed, retard and nudger rolls (2).
Figure 1 Roll removal
Replacement
1. The replacement is the reverse of the removal procedure.
2. If new tray 2 feed, retard and nudger rolls are installed, enter
the HFSI counter 954-801.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord
2.
Figure 1:
dC135 HFSI Counter. Reset

REP 80.16 Bypass Tray Nudger/Feed Roll

Parts List on PL 70.40
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
NOTE: New feed and nudger rolls and a retard pad must be installed at the same time. Refer
to REP 80.17.
1. Remove the bypass tray, REP
2. Remove the upper frame, Figure
a. Remove the spring (1).
b. Remove two crews (2).
c. Remove the upper frame (3).
Figure 1 Upper frame removal
April 2017
4-191
WARNING
GP 10. Disconnect the power cord
70.2.
1:
Repairs and Adjustments
REP 80.15, REP 80.16