Rep 5.14 Feed Roll Assembly - Xerox WorkCentre 5790 Series Service Manual

REP 5.14 Feed Roll Assembly

Parts List on (35 ppm) PL 5.15, (40-90 ppm)
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
1. Open the DADH top cover.
2. Remove the DADH feed roll assembly,
Repairs/Adjustments
REP 5.14
PL 5.17
WARNING
GP 14. Disconnect the power cord from the
Figure 1.
Replacement
1. The replacement is the reverse of the removal procedure. When the feed rolls are
installed, make sure the lowest roll, (retard roll), is positioned as shown in
2. If a new feed roll assembly is installed, select
the copy count to zero.
3. If a new feed roll assembly is installed, reset the DADH feed count to zero in the HFSI fea-
ture screen. Refer to GP 17
May 2013
4-66
1
Completely raise the feed
roll assembly (2 clicks).
2
Raise the feed roll assembly
cover.
3
Remove the feed roll assem-
bly.
NOTE: There are three rollers on the
feed roll cartridge.
If the lower feed roll does not come out
with feed roll assembly, then remove it
separately from the machine.
Figure 1 Feed roll assembly
dC131 chain 5, location 05-001 and reset
High Frequency Service Items.
Xerox® WorkCentre® 5790 Family
Figure 2.