REP 8.6 Bypass Tray Feed Roll Assembly
Parts List on PL 8.20
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
WARNING
Take care during this procedure. Sharp edges may be present that can cause injury.
CAUTION
Before performing this procedure, refer to General Disassembly Precautions, GP 10.
1.
Remove the paper transport assembly, REP 8.3.
2.
Remove the bypass tray retard assembly, REP 8.5
3.
Remove the feed roll assembly support spring, Figure 1.
Figure 1 Spring removal
WorkCentre 4150
4.
1
Remove the
spring.
5.
September 2006
4-39
Remove the paper transport upper guide, Figure 2.
2
Unclip the upper guide (4 places).
Figure 2 Upper guide removal
Remove the feed roll assembly, Figure 3.
1
Remove E-clip and
bearing.
Figure 3 Feed roll removal
1
Remove 4
screws.
4
Remove the upper guide.
3
Disconnect the connector.
2
Remove E-clip and
bearing.
3
Remove the feed roll
assembly.
Repairs and Adjustments
REP 8.6