Dlp- G294 Edit The Osi Router Configuration - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Manage the Node
•
Note
Although Cisco does not recommend changing the LSP buffer sizes, you can adjust the buffers in the
Step 4
following fields:
•
•
Return to your originating procedure (NTP).
Step 5
DLP-G294 Edit the OSI Router Configuration
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Provisioning > OSI > Routers > Setup tabs.
Step 1
Choose the router you want provision and click Edit.
Step 2
In the OSI Router Editor dialog box:
Step 3
a.
b.
c.
d.
September 2005
Intermediate System Level 1/Level 2—The ONS 15454 performs IS functions. It communicates
with IS and ES nodes that reside within its OSI area. It also communicates with IS L1/L2 nodes that
reside in other OSI areas. Before choosing this option, verify the following:
The node is connected to another IS Level 1/Level 2 node that resides in a different OSI area.
–
The node is connected to all nodes within its area that are provisioned as IS L1/L2.
–
Changing a routing mode should be carefully considered. Additional information about OSI ESs
and ISs and the ES-IS and IS-IS protocols are provided in
Connectivity Reference."
L1 LSP Buffer Size—Adjusts the Level 1 link state PDU buffer size.
L2 LSP Buffer Size—Adjusts the Level 2 link state PDU buffer size.
This task allows you to edit the OSI router configuration, including
enabling and disabling OSI routers, editing the primary area address, and
creating or editing additional area addresses.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Check or uncheck the Enabled box to enable or disable the router.
Router 1 must be enabled before you can enable Routers 2 and 3.
Note
For enabled routers, edit the primary area address, if needed. The address can be between
8 and 24 alphanumeric characters in length.
If you want to add or edit an area address to the primary area, enter the address at the bottom of the
Multiple Area Addresses area. The area address can be 2 to 26 numeric characters (0–9) in length.
Click Add.
Click OK.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
DLP-G294 Edit the OSI Router Configuration
Chapter 22, "Management
10-15