Dlp- G219 Change The Txp_Mr_10G Or Txp_Mr_10E Card Line Thresholds For Sonet Or Sdh Payloads - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
DLP-G219 Change the TXP_MR_10G or TXP_MR_10E Card Line Thresholds for
SONET or SDH Payloads
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the TXP_MR_10G or TXP_MR_10E card where you want to change the line
Step 1
threshold settings.
Click the Provisioning > Line Thresholds > SONET Thresholds tabs.
Step 2
Modify any of the settings described in
Step 3
Note
Table 5-6 TXP_MR_10G and TXP_MR_10E Transponder Card Line Threshold Settings
Parameter Description
Port (Display only)
Port number
CV Coding
violations
ES Errored
seconds
September 2005
DLP-G219 Change the TXP_MR_10G or TXP_MR_10E Card Line Thresholds for SONET or SDH Payloads
This task changes the line threshold settings for TXP_MR_10G and
TXP_MR_10E transponder cards carrying SONET or SDH payloads,
including the physical 10G Ethernet WAN payload.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
You must modify Near End and Far End independently; 15 Min and 1 Day independently; and
Line and Section independently. To do so, choose the appropriate radio button and click Refresh.
Options – ONS 15454
1-1 (OC192)
•
2 (Trunk)
•
Numeric. Threshold display options include:
Direction—Near End or Far End
•
Interval—15 Min (minutes) or 1 day
•
• Types—Line or Section (near end only)
Choose an option in each category and click
Refresh.
Numeric. Threshold display options include:
Direction—Near End or Far End
•
Interval—15 Min (minutes) or 1 day
•
Types—Line or Section (near end only)
•
Choose an option in each category and click
Refresh.
Table 5-6.
Options – ONS 15454 SDH
1-1 (STM64)
•
2 (Trunk)
•
Numeric. Threshold display options include:
Direction—Near End or Far End
•
Interval—15 Min (minutes) or 1 day
•
• Types—Multiplex Section or
Regeneration Section (near end only)
Choose an option in each category and click
Refresh.
Numeric. Threshold display options include:
Direction—Near End or Far End
•
Interval—15 Min (minutes) or 1 day
•
Types—Multiplex Section or
•
Regeneration Section (near end only)
Choose an option in each category and click
Refresh.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-19