Dlp- G148 View Otn Pm Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 9 Monitor Performance
Step 5 Return to your originating procedure (NTP).
DLP-G148 View OTN PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the TXP or MXP card where you want to view PM counts. The card view
appears.
Click the Performance > OTN PM > G.709 tabs
Step 2
Figure 9-8
Card View
Performance
G.709 PM
OTN PM tab
Directions
radio buttons
radio buttons
September 2005
Viewing OTN ITU-T G.709 Performance Monitoring Information
tab
tab
Intervals
This task enables you to view the OTN PM counts on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E),
or muxponder (MXP_2.5G_10E, MXP_2.5G_10G) card and port to
detect possible performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure
Signal-type Refresh
port menu button
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
DLP-G148 View OTN PM Parameters
9-8).
Auto-refresh Baseline
menu button
Clear Help
button button
9-25