Dlp- G282 View And Terminate Active Logins - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Manage the Node
Note
Click Edit to make changes to an existing RADIUS server. You can change the IP address, the shared
Step 8
secret, the authentication port, and the accounting port.
Click Delete to delete the selected RADIUS server.
Step 9
Select a server and click Move Up or Move Down to reorder that server in the list of RADIUS
Step 10
authenticators. The node requests authentication from the servers sequentially from top to bottom. If one
server is unreachable, the node will request authentication from the next RADIUS server on the list.
Step 11 Click the Enable RADIUS Authentication check box to activate remote-server authentication for the
node.
Step 12 Click the Enable RADIUS Accounting check box if you want to show RADIUS authentication
information in the audit trail.
Click the Enable the Node as the Final Authenticator check box if you want the node to be the final
Step 13
autheticator. This means that if every RADIUS authenticator is unavailable, the node will authenticate
the login rather than locking the user out.
Step 14 Click Apply to save all changes or Reset to clear all changes.
Return to your originating procedure (NTP).
Step 15
DLP-G282 View and Terminate Active Logins
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > Security > Active Logins tabs. The Active Logins tab displays
Step 1
the following information:
•
•
•
•
•
•
Click Logout to end the session of every logged-in user. This will log out all current users, excluding
Step 2
the initiating Superuser.
September 2005
You can add up to 10 RADIUS servers to a node's list of authenticators.
This procedure allows you to view active CTC logins, retrieve the last
activity time, and terminate all current logins.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher for viewing; Superuser for session termination
User ID
User IP address
Current node the user is logged into
Session Type (EMS, TL1, FTP, telnet, or SSH)
Login time
Last activity time
DLP-G282 View and Terminate Active Logins
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-57