Cisco ONS 15454 DWDM Installation And Operation Manual page 290

NTP-G43 Perform the ROADM Node Acceptance Test
Step 3 Display the ROADM node in node view.
Click the Alarms tab.
Step 4
Verify that the alarm filter is not on. See the
a.
as necessary.
b. Verify that no equipment (EQPT) alarms appear indicating equipment failure or other hardware
problems. If equipment failure alarms appear, investigate and resolve them before continuing. Refer
to the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting
Guide for procedures.
Note
In node view, click the Provisioning > WDM-ANS > Port Status tabs. Verify that all statuses under
Step 5
Link Status are listed as Success - Changed, Success - Unchanged, or Not Applicable. If any are not,
complete the following steps:
Delete the two OSC channels using the
a.
page
Complete the
b.
Create the OSC channels using the
c.
page
Display the east 32WSS in card view.
Step 6
Click the Provisioning > Optical Chn Optical Connector [n] > Parameters tabs, where n = the optical
Step 7
connector number that carries the wavelengths you will test. Refer to
Step 8 Click the Admin State table cell for the Add port carrying the tested wavelength, then choose OOS,MT
(for ANSI) or Locked,maintenance (ETSI) from the drop-down list. For example, if the tested
wavelength is 1530.33 (shown as 1530.3), you would click the Port 1 Admin State field and choose
OOS,MT or Locked,maintenance from the drop-down list.
Step 9 Change the Admin State of the PT port corresponding to the port in
Locked,maintenance (ETSI). For example, if the tested wavelength is 1530.33 (shown as 1530.3), you
would click the Port 33 Admin State field and choose OOS,MT or Locked,maintenance from the
drop-down list. Refer to
Click Apply, then click Yes to confirm.
Step 10
Repeat Steps
Step 11
Display the west 32WSS in card view.
Step 12
Repeat Steps
Step 13
Display the east 32DMX or 32DMX-O in card view and complete the following steps:
Step 14
For a 32DMX card:
Choose the Provisioning > Optical Line > Parameters tabs.
a.
For Port 33, click the Admin State table cell and choose OOS,MT (ANSI) or Locked,maintenance
b.
(ETSI) from the drop-down list.
Click Apply, then click Yes to confirm.
c.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
4-10
The OSC terminations created during node turn-up will generate two alarms for each side of the
shelf, one for LOS on the OPT-BST card, and the other an LOS alarm on the OSC-CSM or
OSCM card.
10-41.
"NTP-G37 Run Automatic Node Setup" procedure on page
3-84.
Table 4-2 on page
7 through 10 for all wavelengths that you will test.
7 through 10 for the west 32WSS card.
"DLP-G128 Disable Alarm Filtering" task on page 8-28
"DLP-G186 Delete an OSC Termination" task on
"NTP-G38 Provision OSC Terminations" procedure on
4-9, if needed.
Chapter 4 Perform Node Acceptance Tests
3-83.
Table 4-2 on page 4-9, if needed.
Step 8 to OOS,MT (ANSI) or
September 2005