Figure - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Create Channels and Circuits
Note
Complete one of the following:
Step 8
•
•
If you want to save the information in the CTC Alerts dialog box, complete the following steps. If you
Step 9
do not want to save it, continue with
a.
b.
c.
Click Close to close the CTC Alerts dialog box.
Step 10
Complete the
Step 11
your changes.
Return to your originating procedure (NTP).
Step 12
NTP-G60 Create Overhead Circuits
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
overhead circuit. If you are already logged in, continue with Step 2.
Choose View > Go to Network View.
Step 2
As needed, complete the
Step 3
As needed, complete the
Step 4
Step 5 As needed, complete the
September 2005
The CTC Alerts dialog box will not automatically open to show a deletion error unless you
checked All alerts or Error alerts only in the CTC Alerts dialog box. For more information, see
the "DLP-G53 Configure the CTC Alerts Dialog Box for Automatic Popup" task on page
If the CTC Alerts dialog box is not set to open automatically with a notification, the red triangle
inside the CTC Alerts toolbar icon indicates that a notification exists.
If you checked Notify when completed, the CTC Alerts dialog box appears. If you want to save the
information, continue with
If you did not check Notify when completed, the Circuits window appears. Continue with
Click Save.
Click Browse and navigate to the directory where you want to save the file.
Type the file name using a .txt file extension, and click OK.
"NTP-G103 Back Up the Database" procedure on page 13-2
This procedure creates overhead circuits on an ONS 15454 network.
Overhead circuits include generic communications channels (GCCs),
IP-encapsulated tunnels, the AIC-I card orderwire, and the AIC-I card
UDC.
None
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G76 Provision GCC Terminations" task on page
"DLP-G97 Provision a Proxy Tunnel" task on page
"DLP-G98 Provision a Firewall Tunnel" task on page
Step 9. If you do not want to save the information, continue with
Step 10.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G60 Create Overhead Circuits
if you require a backup of
at the node where you will create the
7-14.
7-15.
7-16.
2-32.
Step 10.
Step 11.
7-13