Cisco ONS 15454 DWDM Installation And Operation Manual page 313

Chapter 4 Perform Node Acceptance Tests
i. Wait 90 seconds, then in node view click the Alarms tab. Verify that the LOS alarm on the OSCM
card has cleared. If so, replace the OPT-BST card. If not, replace the OSCM card. See the
Install the DWDM Cards" procedure on page
Connect the tunable laser transmitter or the TXP_MR_2.5G card DWDM TX port to the OSC-CSM
Step 26
LINE RX port using a 10-dB bulk attenuator.
If an OPT-PRE is installed on the same side of the shelf as the OSC-CSM, complete the
Step 27
Verify the OPT-PRE Amplifier Laser and Power" task on page
Step 28 Complete the
OPT-BST card.
Display the OSC-CSM card in card view.
Step 29
Click the Provisioning > Optical Line > Parameters tabs. Verify that the power value on Port 3
Step 30
(Out Com) is equal to the optical power from the tunable laser or TXP_MR_2.5G card (measured in
Step
If an OPT-PRE card is installed on the side opposite the OSC-CSM, complete the
Step 31
OPT-PRE Amplifier Laser and Power" task on page
Disconnect the TXP or tunable laser from the OSC-CSM card.
Step 32
Step 33 Remove the loopback fiber on the OPT-BST amplifier card.
Delete both OSC channels. See the
Step 34
Complete the
Step 35
configuration.
Step 36 Create the OSC channels using the
Stop. You have completed this procedure.
September 2005
NTP-G47 Perform the Line Amplifier Node with OSCM and OSC-CSM Cards Acceptance Test
"DLP-G79 Verify the OPT-BST Amplifier Laser and Power" task on page 4-40
10) +/– 1 dBm.
"NTP-G37 Run Automatic Node Setup" procedure on page 3-83
3-39.
4-41. If not, continue with
"DLP-G186 Delete an OSC Termination" task on page
"NTP-G38 Provision OSC Terminations" procedure on page
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
4-41. If not, continue with
"DLP-G80 Verify the
Step 32.
to restore the original
"NTP-G30
"DLP-G80
Step 27.
for the
10-41.
3-84.
4-33