Dlp- G229 Change Card Settings For Txp_Mr_2.5G And Txpp_Mr_2.5G Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
DLP-G229 Change Card Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the TXP_MR_2.5G or TXPP_MR_2.5G card where you want to change the
Step 1
card settings.
Click the Provisioning > Card tabs.
Step 2
Modify any of the settings described in
Step 3
Table 5-29
Parameter
Termination
Mode
Wavelength
September 2005
DLP-G229 Change Card Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
This task changes the card settings for TXP_MR_2.5G and
TXPP_MR_2.5G transponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card Settings
Description
Sets the mode of operation (option only
supported for SONET/SDH payloads).
See the "16.12 Termination Modes"
section on page 16-117 for more
information.
Sets the wavelength of the DWDM side
optical transmitter.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-29.
Options
Transparent
•
Section (ANSI) or Regeneration
•
Section (ETSI)
Line (ANSI) or Multiplex Section
•
(ETSI)
• First Tunable Wavelength
• Further wavelengths in 100-GHz ITU
spacing
• Supported wavelengths are in white
and marked by asterisks (**);
unsupported wavelengths are gray.
The four available wavelengths
Note
are listed in the Card Parameters
section of the window and also in
the Maintenance > Info tab.
5-49