Dlp- G228 Change Line Otn Settings For Mxp_2.5G_10G And Mxp_2.5G_10E Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Table 5-24
Port Type
(by CTC)
OC-48
STM-16
Click Apply.
Step 8
Step 9 Repeat Steps
Return to your originating procedure (NTP).
Step 10
DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E
Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
Step 1
line OTN settings.
Click the Provisioning > OTN tabs, then choose one of the following subtabs: OTN Lines,
Step 2
OTN G.709 Thresholds, FEC Thresholds, or Trail Trace Identifier.
Modify any of the settings described in Tables
Step 3
Note
Table 5-25
Note
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-44
MXP_2.5G_10G and MXP_2.5G_10E Card Client Interface Alarm Thresholds
Pluggable Port Module
(SFP)
ONS-SE-2G-S1
15454-SFP-OC48-IR
ONS-SE-2G-S1
15454E-SFP-L.16.1
7 and 8 to provision each additional client port. Otherwise, continue with
This task changes the line OTN settings for MXP_2.5G_10G and
MXP_2.5G_10E muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
You must modify Near End, and Far End independently; 15 Min and 1 Day independently; and
SM and PM independently. To do so, choose the appropriate radio button and click Refresh.
describes the values on the Provisioning > OTN > OTN Lines tab.
In Table 5-25, some parameter tabs or values do not always apply to both the MXP_2.5G_10G
and the MXP_2.5G_10E card. When the tabs or values do not apply, they do not appear to the
user.
Chapter 5
Alarm RX Alarm RX
Power Low Power High
-21 0
-21 3
-21 0
-21 3
5-25 through 5-28.
Provision Transponder and Muxponder Cards
Alarm TX Alarm TX
Power Low Power High
-13 0
-8 3
-13 0
-8 3
Step
September 2005
10.