Dlp- G181 Apply A Lock-On - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Manage the Node
DLP-G181 Apply a Lock-On
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You can apply the Lock On command only to the working/active card or port. If the working card or port
Note
is standby (traffic is switched), the Lock Out button is not available.
Step 1 In node view, click the Maintenance > Protection tabs.
In the Protection Groups area, click the protection group that contains the card (Y-cable) or port (splitter)
Step 2
that you want to lock on.
Step 3 In the Selected Group area, click the working/active card.
Step 4 In the Inhibit Switching drop-down list, click Lock On.
Step 5 Click Yes in the confirmation dialog box.
The lock-on has been applied. Traffic cannot switch to the protect card. To clear the lock-on, see the
"DLP-G183 Clear a Lock-On or Lockout" task on page
Note
Return to your originating procedure (NTP).
Step 6
DLP-G182 Apply a Lockout
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You can apply the lockout to the protect/standby card or port. If the protect card or port is active (traffic
Note
is switched), the lockout task cannot be performed.
September 2005
This task prevents traffic from being switched from the working/active
card in a Y-cable protection group or port in a splitter protection group.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Maintenance or higher
Provisioning a lock-on raises a LOCKON-REQ or an FE-LOCKON condition in CTC. Clearing
the lock on switch request clears these conditions.
This task keeps traffic from switching to the protect/standby card or
port. The Lock Out command overrides the Force and Manual switching
commands.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Maintenance or higher
10-38.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
DLP-G181 Apply a Lock-On
10-37